Hardware Electronics Engineer

Design the boards behind our connected products — schematic, layout, bring-up and debug — and be the person who gets a prototype working by Friday.

Design schematics for connected consumer products — power, sensing, wireless, interface — and own the component selection behind them Lay out multi-layer PCBs with proper attention to grounding, decoupling, impedance, EMI and manufacturability Bring up new boards and debug them to a working state, with a scope, a logic analyser and a method Write enough embedded code to validate your hardware, then hand over cleanly to firmware Build test rigs and harnesses so board validation is a repeatable sequence rather than an improvisation each time Work with mechanical and industrial design on board outline, connector placement, antenna keep-outs and thermal paths — early, not after the enclosure is fixed Manage fab and assembly vendors: BOM, gerbers, pick-and-place files, DFM feedback, first article review Document every board you own — schematic revision, BOM, pin map, flashing procedure, known issues — to a standard a stranger could work from Support products through EMC pre-scan and certification, and act on what the scan finds

3–6 years designing electronics for products that were built, not just prototyped on a dev board Strong schematic and PCB layout ability in a professional tool — Altium, KiCad, OrCAD or Eagle — including multi-layer boards Demonstrable bring-up and debug skill: you can describe the hardest bug you found and exactly how you found it Comfortable with embedded C at the register level, enough to prove a peripheral works Hands-on with the bench — soldering, rework down to fine-pitch parts, scope, logic analyser, bench supply You have worked with a fab or assembly house and dealt with their DFM feedback Something you built for yourself, outside work, that you can show us Based in Bengaluru or willing to relocate; this is a bench job and it is on-site

Degree or diploma in electronics, electrical, instrumentation or communications engineering Low-power or battery-powered product experience — power budgets, sleep modes, charging Exposure to EMC, radio or safety certification, in India or internationally Experience with sensor integration, analog signal conditioning, or RF layout inside a difficult enclosure